LCC-10 Single Axis Controller/Servo Drive
Type: LCC-10/LCC-11
Enkelt akset controller med indbygget forstærker til enfaset børstet og 3-faset børsteløs motor og aktuator, 10 bit analog udgang. 16-bit, 0-10VDC valgfri (LCC-11)
- Enfaset / 3-faset børsteløs motor
- Tilstand: Positionshastighedskraft
- Indbygget forstærker
- Nem udvidelse til flerakse
- 24-48VDC
- 4TTL input / output
- 2 analoge indgange, 1 analog udgang, 10 bit (16 bit valgfri som LCC-11)
- RS232 og CAN bus interface
- Kan kun køres som drive
LCC Specifications
LAC-1 and LCC comparison
Tilbehør
RS232 kit
LCC Daisy Chain kit specifications
LCC Demo Board specifications (for demo and test purposes only)
LCC Opto Board specifications
Electronic Break out Board
SMAC Control Center installation Instructions
SMAC Control Center Get Started Manual
How to use SMAC Control Center quick and efficient.
SMAC Control Center Training v1.2
Full training manual for the SMAC Control Center. The Exercise solutions can be found in the Motion Samples tab of this site
Embedded Motion Control Library
All commands of the LCC10 and LCC11 controller.
Motionlab manual
How to use MotionLab Software.
Composer manual
How to use Composer Software.
Firmware Loader manual
How to use the Firmware Loader Software.
Technical Notes:
Measuring forces with LCC
Control Tuning
Serial to PC/PLC
Homing
Soft-Land
Analog I/O
Phase Detection
Interrupt
I2T
Reset Error
Write to Non Volatile
Back EMF
Broken Wire Detection
Spring compensation
